Setup & Safety Instructions
Follow these steps to ensure a safe and stable play environment for children.
1 Site Selection
- Surface Check: Inspect the ground for sharp objects. Do not install over concrete, asphalt, or any hard surfaces.
- Clearance: Place on a soft, level surface at least 2 meters away from fences, garages, houses, or electrical wires.
- Safety Zone: Keep away from water and potential fire hazards. Ensure the play area is free from furniture or sharp obstacles.
2 Electrical & Blower Setup
- Keep the blower and power cord away from moisture. If water contacts the blower, unplug immediately and do not operate until completely dry.
- Plug into an approved grounded outlet with the switch in the OFF position first. Avoid tripping hazards with the cord.
- Attach the inflation tube to the blower securely. Ensure the tube is straight and untwisted.
3 Anchoring & Stabilization
For items with Water Bags: Fill bags to 80% (approx. 22kg) before full inflation. Never allow play without water bags installed.
Ground Stakes: Drive stakes deep into the ground through the blower base holes and bouncer loops to prevent overturning or lifting during play.
Critical Safety Alerts
- Continual Airflow: The blower must remain ON at all times during use. Inflation typically takes less than 2 minutes.
- Normal Air Leakage: Hissing sounds from seams are normal and required to prevent over-inflation.
- Sun Glare: Position slides away from direct sun to prevent glare and heat on the sliding surface.
- Weight Limits: Do not exceed the age recommendations or total user weights printed on the product.
